Hardware number · 2 files

8K1907115G original ECU files

2 original (stock) ECU files with the hardware number 8K1907115G — Bosch MED17.5, Bosch MED17, used in Audi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

2files
2ECU types
1models
1makes

All 8K1907115G files 2

VehicleECUHWSWCalibration / upgrade
1037395026 8K1907115G 0003 Audi A41.8 160hp · CABBMap pack · 72 maps Bosch MED17 — 1037395026 8K1907115G 0003 €20 · OpenWith maps €60
8K1907115G 0004 Audi A41.8 16v TFSI 160hp · CABB Bosch MED17.5 8K1907115G 0004 8K1907115G 0004 €20 · Open

About 8K1907115G

8K1907115G is on 2 original (stock) ECU files in our catalogue: as the calibration on 2 files, as the hardware number on 1 file and as the SW upgrade number on 1 file.

They were read from Bosch MED17 (1 file) and Bosch MED17.5 (1 file) control units.

Our catalogue lists them for the Audi A4 (1.8 16v TFSI 160hp).

Other numbers on these files: 1 software number (1037395026), listed on 1 of the 2 files.

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
8K1907115G
Files
2
Found as
calibration, hardware number and SW upgrade number
ECU types
2
Vehicles
1
Also written as
8K1 907 115 G

ECU types with 8K1907115G 2

Vehicles with 8K1907115G 1

More Bosch MED17.5 numbers 24

Need a modified file?

Tuning for 8K1907115G — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is 8K1907115G listed for?

In our catalogue: Audi A4 (1.8 16v TFSI 160hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has 8K1907115G?

In our catalogue 8K1907115G is on files read from Bosch MED17 (1 file) and Bosch MED17.5 (1 file) control units.

There are several 8K1907115G files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.