8K1927156M original ECU files
2 original (stock) ECU files with the part number 8K1927156M — Temic DL501 GEN2, Temic DL501, used in Audi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 8K1927156M files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 8K1927156M 0012 Audi A53.0 240hp | Temic DL501 | — | — | 8K1927156M 0012 | €20 · Open |
| 0B5927156F A02087 Audi S43.0 333hp | Temic DL501 GEN2 | 0B5927156F | A02087 | 8K1927156M 0004 | €20 · Open |
No file in this list matches. Search all original files →
About 8K1927156M
8K1927156M is on 2 original (stock) ECU files in our catalogue: as the calibration on 2 files and as the SW upgrade number on 2 files.
They were read from Temic DL501 (1 file) and Temic DL501 GEN2 (1 file) control units.
Our catalogue lists them for the Audi A5 (3.0 240hp) and Audi S4 (3.0 333hp).
Other numbers on these files: 1 hardware number (0B5927156F), listed on 1 of the 2 files; 1 software number (A02087), listed on 1 of the 2 files.
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 8K1927156M
- Files
- 2
- Found as
- calibration and SW upgrade number
- ECU types
- 2
- Vehicles
- 2
- Also written as
- 8K1 927 156 M
ECU types with 8K1927156M 2
Vehicles with 8K1927156M 2
Tuning for 8K1927156M — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 8K1927156M listed for?
In our catalogue: Audi A5 (3.0 240hp) and Audi S4 (3.0 333hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 8K1927156M?
In our catalogue 8K1927156M is on files read from Temic DL501 (1 file) and Temic DL501 GEN2 (1 file) control units.
There are several 8K1927156M files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.