Hardware number · 3 files

V38MA-00008 original ECU files

3 original (stock) ECU files with the hardware number V38MA-00008 — Denso, used in Kubota vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

3files
1ECU types
1models
1makes

All V38MA-00008 files 3

VehicleECUHWSWCalibration / upgrade
Kubota M110GX3.8 108hp · V3800-CR-TIE4Map pack · 27 maps Denso V38MA-00008 — — €20 · OpenWith maps €90
Kubota M110GX3.8 108hp · V3800-CR-TIE4 Denso V38MA-00008 — — €20 · Open
N817KB05 Kubota M110GX3.8 108hp · V3800-CR-TIE4 Denso V38MA-00008 N817KB05 — €20 · Open

About V38MA-00008

V38MA-00008 is on 3 original (stock) ECU files in our catalogue, always as the hardware number.

They were read from Denso control units.

Our catalogue lists them for the Kubota M110GX (3.8 108hp).

Other numbers on these files: 1 software number (N817KB05), listed on 1 of the 3 files.

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy. 2 of these files have the same numbers, ECU, vehicle and engine as another file in this list.

Number
V38MA-00008
Files
3
Found as
hardware number
ECU types
1
Vehicles
1
Also written as
V38MA00008 · V38MA 00008

Vehicles with V38MA-00008 1

More Denso numbers 24

Need a modified file?

Tuning for Denso — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is V38MA-00008 listed for?

In our catalogue: Kubota M110GX (3.8 108hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has V38MA-00008?

In our catalogue V38MA-00008 is on files read from Denso control units.

There are several V38MA-00008 files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.