R2BF-188K1 original ECU files
2 original (stock) ECU files with the hardware number R2BF-188K1 — Denso, Denso RF8B, used in Mazda vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All R2BF-188K1 files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| R2BF-18881-D Mazda 62.2 163hp | Denso | R2BF-188K1 | R2BF-18881-D | R2BF-188K2-D | €20 · Open |
| R2BH-18881-A Mazda 62.2 163hp | Denso RF8B | R2BF-188K1 | R2BH-18881-A | R2BH-188K2-A | €20 · Open |
No file in this list matches. Search all original files →
About R2BF-188K1
R2BF-188K1 is on 2 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Denso RF8B (1 file) control units; the ECU model is not recorded for 1 file.
Our catalogue lists them for the Mazda 6 (2.2 163hp).
Other numbers on these files: 2 software numbers (R2BF-18881-D, R2BH-18881-A); 2 calibration / SW upgrade numbers (R2BF-188K2-D, R2BH-188K2-A).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- R2BF-188K1
- Files
- 2
- Found as
- hardware number
- ECU types
- 1
- Vehicles
- 1
- Also written as
- R2BF188K1 · R2BF 188K1
ECU types with R2BF-188K1 1
Vehicles with R2BF-188K1 1
More Denso numbers 24
Tuning for R2BF-188K1 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is R2BF-188K1 listed for?
In our catalogue: Mazda 6 (2.2 163hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has R2BF-188K1?
In our catalogue R2BF-188K1 is on files read from Denso RF8B (1 file) control units; the ECU model is not recorded for 1 file.
There are several R2BF-188K1 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.