PSM5-18881-B original ECU files
2 original (stock) ECU files with the software number PSM5-18881-B — Denso, Denso SH725X, used in Mazda vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All PSM5-18881-B files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| PSM5-188K2-B Mazda 32.0 165hp | Denso SH725X | — | PSM5-18881-B | PSM5-18881-B PSM5-188K2-B | €20 · Open |
| PSM6-188K1- Mazda MX52.0 160hp | Denso | PSM6-188K1- | PSM5-18881-B | PSM5-188K2-B | €20 · Open |
No file in this list matches. Search all original files →
About PSM5-18881-B
PSM5-18881-B is on 2 original (stock) ECU files in our catalogue: as the software number on 2 files and as the calibration on 1 file.
They were read from Denso SH725X (1 file) control units; the ECU model is not recorded for 1 file.
Our catalogue lists them for the Mazda 3 (2.0 165hp) and Mazda MX5 (2.0 160hp).
Other numbers on these files: 1 calibration / SW upgrade number (PSM5-188K2-B).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- PSM5-18881-B
- Files
- 2
- Found as
- software number and calibration
- ECU types
- 1
- Vehicles
- 2
- Also written as
- PSM518881B · PSM5 18881 B
ECU types with PSM5-18881-B 1
Vehicles with PSM5-18881-B 2
More Denso numbers 24
Tuning for PSM5-18881-B — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is PSM5-18881-B listed for?
In our catalogue: Mazda 3 (2.0 165hp) and Mazda MX5 (2.0 160hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has PSM5-18881-B?
In our catalogue PSM5-18881-B is on files read from Denso SH725X (1 file) control units; the ECU model is not recorded for 1 file.
There are several PSM5-18881-B files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.