H16HRA6 original ECU files
2 original (stock) ECU files with the hardware number H16HRA6 — Denso SH7058, used in Mitsubishi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All H16HRA6 files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| T1R1HDR1DH01 Mitsubishi Lancer1.8 16v DI-D 116hp | Denso SH7058 | H16HRA6 | T1R1HDR1DH01 | H16HRA6 T1R1HDR1DH01 1860C12902 | €20 · Open |
| T1R1HDR1DK01 Mitsubishi Lancer1.8 16v DI-D 116hp | Denso SH7058 | H16HRA6 | T1R1HDR1DK01 | H16HRA6 T1R1HDR1DK01 1860C12502 | €20 · Open |
No file in this list matches. Search all original files →
About H16HRA6
H16HRA6 is on 2 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Denso SH7058 (2 files) control units.
Our catalogue lists them for the Mitsubishi Lancer (1.8 16v DI-D 116hp).
Other numbers on these files: 2 software numbers (T1R1HDR1DH01, T1R1HDR1DK01); 2 calibration / SW upgrade numbers (1860C12902, 1860C12502).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- H16HRA6
- Files
- 2
- Found as
- hardware number
- ECU types
- 1
- Vehicles
- 1
ECU types with H16HRA6 1
Vehicles with H16HRA6 1
More Denso SH7058 numbers 24
Tuning for Denso SH7058 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is H16HRA6 listed for?
In our catalogue: Mitsubishi Lancer (1.8 16v DI-D 116hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has H16HRA6?
In our catalogue H16HRA6 is on files read from Denso SH7058 (2 files) control units.
There are several H16HRA6 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.