Hardware number · 2 files

H153RA6 original ECU files

2 original (stock) ECU files with the hardware number H153RA6 — Denso SH7058, used in Mitsubishi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

2files
1ECU types
2models
1makes

All H153RA6 files 2

VehicleECUHWSWCalibration / upgrade
T1J3HDJ36301 Mitsubishi ASX1.8 150hp Denso SH7058 H153RA6 T1J3HDJ36301 H153RA6 T1J3HDJ36301 1860B42105 €20 · Open
T1J3HDJ36A01 Mitsubishi Outlander2.3 165hp Denso SH7058 H153RA6 T1J3HDJ36A01 H153RA6 T1J3HDJ36A01 1860B61403 €20 · Open

About H153RA6

H153RA6 is on 2 original (stock) ECU files in our catalogue, always as the hardware number.

They were read from Denso SH7058 (2 files) control units.

Our catalogue lists them for the Mitsubishi ASX (1.8 150hp) and Mitsubishi Outlander (2.3 165hp).

Other numbers on these files: 2 software numbers (T1J3HDJ36301, T1J3HDJ36A01); 2 calibration / SW upgrade numbers (1860B42105, 1860B61403).

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
H153RA6
Files
2
Found as
hardware number
ECU types
1
Vehicles
2

ECU types with H153RA6 1

Vehicles with H153RA6 2

More Denso SH7058 numbers 24

Need a modified file?

Tuning for Denso SH7058 — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is H153RA6 listed for?

In our catalogue: Mitsubishi ASX (1.8 150hp) and Mitsubishi Outlander (2.3 165hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has H153RA6?

In our catalogue H153RA6 is on files read from Denso SH7058 (2 files) control units.

There are several H153RA6 files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.