03G906018CR original ECU files
3 original (stock) ECU files with the software number 03G906018CR — Siemens PPD1.2, used in Volkswagen vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 03G906018CR files 3
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 8428 03G906018CR Volkswagen Passat 62.0 140hp | Siemens PPD1.2 | 8428 | 03G906018CR | 03G906018CR 8428 | €20 · Open |
| 9674 03G906018CR Volkswagen Passat 62.0 140hpMap pack · 81 maps | Siemens PPD1.2 | 9674 | 03G906018CR | 03G906018CR 9674 | €20 · OpenWith maps €60 |
| 9970 03G906018CR Volkswagen Passat 62.0 TDI 140hp · BWV | Siemens PPD1.2 | 9970 | 03G906018CR | 03G906018CR 9970 | €20 · Open |
No file in this list matches. Search all original files →
About 03G906018CR
03G906018CR is on 3 original (stock) ECU files in our catalogue: as the software number on 3 files, as the calibration on 3 files and as the SW upgrade number on 3 files.
They were read from Siemens PPD1.2 (3 files) control units.
Our catalogue lists them for the Volkswagen Passat 6 (2.0 TDI 140hp).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 03G906018CR
- Files
- 3
- Found as
- software number, calibration and SW upgrade number
- ECU types
- 1
- Vehicles
- 1
- Also written as
- 03G 906 018 CR
ECU types with 03G906018CR 1
Vehicles with 03G906018CR 1
Tuning for Siemens PPD1.2 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 03G906018CR listed for?
In our catalogue: Volkswagen Passat 6 (2.0 TDI 140hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 03G906018CR?
In our catalogue 03G906018CR is on files read from Siemens PPD1.2 (3 files) control units.
There are several 03G906018CR files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.