Software number · 2 files

TFG3HFG39402 original ECU files

2 original (stock) ECU files with the software number TFG3HFG39402 — Denso SH7059, Denso MA275700-8921, used in Mitsubishi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

2files
2ECU types
1models
1makes

All TFG3HFG39402 files 2

VehicleECUHWSWCalibration / upgrade
H18JCR5 Mitsubishi L2002.5 176hp Denso MA275700-8921 H18JCR5 TFG3HFG39402 1860B70107 €20 · Open
H18JCR59 Mitsubishi L2002.5 176hp Denso SH7059 H18JCR59 TFG3HFG39402 H18JCR59 TFG3HFG39402 1860B70107 €20 · Open

About TFG3HFG39402

TFG3HFG39402 is on 2 original (stock) ECU files in our catalogue, always as the software number.

They were read from Denso MA275700-8921 (1 file) and Denso SH7059 (1 file) control units.

Our catalogue lists them for the Mitsubishi L200 (2.5 176hp).

Other numbers on these files: 2 hardware numbers (H18JCR5, H18JCR59); 1 calibration / SW upgrade number (1860B70107).

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
TFG3HFG39402
Files
2
Found as
software number
ECU types
2
Vehicles
1

ECU types with TFG3HFG39402 2

Vehicles with TFG3HFG39402 1

More Denso SH7059 numbers 24

Need a modified file?

Tuning for TFG3HFG39402 — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is TFG3HFG39402 listed for?

In our catalogue: Mitsubishi L200 (2.5 176hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has TFG3HFG39402?

In our catalogue TFG3HFG39402 is on files read from Denso MA275700-8921 (1 file) and Denso SH7059 (1 file) control units.

There are several TFG3HFG39402 files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.