8X2314C568DA original ECU files
3 original (stock) ECU files with the hardware number 8X2314C568DA — Denso MB279700, used in Jaguar vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 8X2314C568DA files 3
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 8X23-14C570-DBE Jaguar XF3.0 238hp · AJ30 | Denso MB279700 | 8X2314C568DA | — | 8X23-14C570-DBE | €20 · Open |
| X23-14C570-DBD Jaguar XF3.0 238hp | Denso MB279700 | 8X2314C568DA | X23-14C570-DBD | X23-14C570-DBD | €20 · Open |
| X23-14C570-DBE Jaguar XF3.0 238hp | Denso MB279700 | 8X2314C568DA | X23-14C570-DBE | X23-14C570-DBE | €20 · Open |
No file in this list matches. Search all original files →
About 8X2314C568DA
8X2314C568DA is on 3 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Denso MB279700 (3 files) control units.
Our catalogue lists them for the Jaguar XF (3.0 238hp).
Other numbers on these files: 2 software numbers (X23-14C570-DBD, X23-14C570-DBE), listed on 2 of the 3 files; 1 calibration / SW upgrade number (8X23-14C570-DBE), listed on 1 of the 3 files.
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 8X2314C568DA
- Files
- 3
- Found as
- hardware number
- ECU types
- 1
- Vehicles
- 1
ECU types with 8X2314C568DA 1
Vehicles with 8X2314C568DA 1
Tuning for Denso MB279700 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 8X2314C568DA listed for?
In our catalogue: Jaguar XF (3.0 238hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 8X2314C568DA?
In our catalogue 8X2314C568DA is on files read from Denso MB279700 (3 files) control units.
There are several 8X2314C568DA files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.