Part number · 2 files

8S0906259N original ECU files

2 original (stock) ECU files with the part number 8S0906259N — Siemens SIMOS 18.10, used in Audi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

2files
1ECU types
1models
1makes

All 8S0906259N files 2

VehicleECUHWSWCalibration / upgrade
8V0906259N 0001 Audi S32.0 310hp · CJXE Siemens SIMOS 18.10 8V0906259N 0001 8S0906259N 0002 €20 · Open
8S0906259N 0003 Audi S32.0 310hp Siemens SIMOS 18.10 8S0906259N 0003 8S0906259N 0003 €20 · Open

About 8S0906259N

8S0906259N is on 2 original (stock) ECU files in our catalogue: as the SW upgrade number on 2 files, as the calibration on 2 files and as the hardware number on 1 file.

They were read from Siemens SIMOS 18.10 (2 files) control units.

Our catalogue lists them for the Audi S3 (2.0 310hp).

Other numbers on these files: 1 hardware number (8V0906259N), listed on 1 of the 2 files.

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
8S0906259N
Files
2
Found as
SW upgrade number, calibration and hardware number
ECU types
1
Vehicles
1
Also written as
8S0 906 259 N

ECU types with 8S0906259N 1

Vehicles with 8S0906259N 1

More Siemens SIMOS 18.10 numbers 23

Need a modified file?

Tuning for Siemens SIMOS 18.10 — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is 8S0906259N listed for?

In our catalogue: Audi S3 (2.0 310hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has 8S0906259N?

In our catalogue 8S0906259N is on files read from Siemens SIMOS 18.10 (2 files) control units.

There are several 8S0906259N files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.