Hardware number · 3 files

4G0906014E original ECU files

3 original (stock) ECU files with the hardware number 4G0906014E — Bosch MED17.1.1, used in Audi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

3files
1ECU types
2models
1makes

All 4G0906014E files 3

VehicleECUHWSWCalibration / upgrade
4G0906014E 0006 Audi RS74.0 420hp · CEUCMap pack · 181 maps Bosch MED17.1.1 4G0906014E 0006 4G0906014E 0006 €20 · OpenWith maps €60
4G0906014E 0002 Audi S64.0 420hp · CEUC Bosch MED17.1.1 — — 4G0906014E 0002 €20 · Open
4G0906014E 0004 Audi S64.0 420hp · CEUC Bosch MED17.1.1 4G0906014E 0004 4G0906014E 0004 €20 · Open

About 4G0906014E

4G0906014E is on 3 original (stock) ECU files in our catalogue: as the SW upgrade number on 3 files, as the calibration on 3 files and as the hardware number on 2 files.

They were read from Bosch MED17.1.1 (3 files) control units.

Our catalogue lists them for the Audi S6 (4.0 420hp) and Audi RS7 (4.0 420hp).

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
4G0906014E
Files
3
Found as
SW upgrade number, calibration and hardware number
ECU types
1
Vehicles
2
Also written as
4G0 906 014 E

ECU types with 4G0906014E 1

Vehicles with 4G0906014E 2

More Bosch MED17.1.1 numbers 24

Need a modified file?

Tuning for Bosch MED17.1.1 — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is 4G0906014E listed for?

In our catalogue: Audi S6 (4.0 420hp) and Audi RS7 (4.0 420hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has 4G0906014E?

In our catalogue 4G0906014E is on files read from Bosch MED17.1.1 (3 files) control units.

There are several 4G0906014E files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.