Hardware number · 2 files

1860C18401 original ECU files

2 original (stock) ECU files with the hardware number 1860C18401 — Denso RA6, Denso MA275700-8921, used in Mitsubishi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

2files
2ECU types
1models
1makes

All 1860C18401 files 2

VehicleECUHWSWCalibration / upgrade
T1U2HDU2J101 Mitsubishi L2002.5 136hp · 4D56IT3 Denso RA6 1860C18401 T1U2HDU2J101 H16ZRA6 €20 · Open
Mitsubishi L2002.5 178hp Denso MA275700-8921 — — 1860C18401 €20 · Open

About 1860C18401

1860C18401 is on 2 original (stock) ECU files in our catalogue: as the hardware number on 1 file, as the SW upgrade number on 1 file and as the calibration on 1 file.

They were read from Denso RA6 (1 file) and Denso MA275700-8921 (1 file) control units.

Our catalogue lists them for the Mitsubishi L200 (2.5 136hp, 2.5 178hp).

Other numbers on these files: 1 software number (T1U2HDU2J101), listed on 1 of the 2 files; 1 calibration / SW upgrade number (H16ZRA6), listed on 1 of the 2 files.

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
1860C18401
Files
2
Found as
hardware number, SW upgrade number and calibration
ECU types
2
Vehicles
1

ECU types with 1860C18401 2

Vehicles with 1860C18401 1

More Denso RA6 numbers 21

Need a modified file?

Tuning for 1860C18401 — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is 1860C18401 listed for?

In our catalogue: Mitsubishi L200 (2.5 136hp, 2.5 178hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has 1860C18401?

In our catalogue 1860C18401 is on files read from Denso RA6 (1 file) and Denso MA275700-8921 (1 file) control units.

There are several 1860C18401 files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.