swtnp004-swdxe007 original ECU files
3 original (stock) ECU files with the calibration swtnp004-swdxe007 — Rover MEMS3, used in Land Rover vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All swtnp004-swdxe007 files 3
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| Land Rover Discovery2.5 138hp | Rover MEMS3 | — | — | swtnp004-swdxe007 | €20 · Open |
| Land Rover Discovery2.5 138hp | Rover MEMS3 | — | — | swtnp004-swdxe007 | €20 · Open |
| Land Rover Discovery2.5 138hp | Rover MEMS3 | — | — | swtnp004-swdxe007 | €20 · Open |
No file in this list matches. Search all original files →
About swtnp004-swdxe007
swtnp004-swdxe007 is on 3 original (stock) ECU files in our catalogue, always as the calibration.
They were read from Rover MEMS3 (3 files) control units.
Our catalogue lists them for the Land Rover Discovery (2.5 138hp).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy. 3 of these files have the same numbers, ECU, vehicle and engine as another file in this list.
- Number
- swtnp004-swdxe007
- Files
- 3
- Found as
- calibration
- ECU types
- 1
- Vehicles
- 1
- Also written as
- swtnp004swdxe007 · swtnp004 swdxe007
ECU types with swtnp004-swdxe007 1
Vehicles with swtnp004-swdxe007 1
Tuning for Rover MEMS3 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is swtnp004-swdxe007 listed for?
In our catalogue: Land Rover Discovery (2.5 138hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has swtnp004-swdxe007?
In our catalogue swtnp004-swdxe007 is on files read from Rover MEMS3 (3 files) control units.
There are several swtnp004-swdxe007 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.