Software number · 3 files

UCF52A00 original ECU files

3 original (stock) ECU files with the software number UCF52A00 — Delphi DCM3.7, used in Ssangyong vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

3files
1ECU types
1models
1makes

All UCF52A00 files 3

VehicleECUHWSWCalibration / upgrade
UCF52A30 D20DTR Ssangyong Stavic2.0 155hp · D20DTR Delphi DCM3.7 — UCF52A00 UCF52A30 D20DTR A151AT5 €20 · Open
UCF52A30 D20DTR Ssangyong Stavic2.0 155hp Delphi DCM3.7 — UCF52A00 UCF52A30 D20DTR A151AT5 €20 · Open
UCF52A32 D20DTR Ssangyong Stavic2.0 155hp Delphi DCM3.7 — UCF52A00 UCF52A32 D20DTR A150AT5 €20 · Open

About UCF52A00

UCF52A00 is on 3 original (stock) ECU files in our catalogue, always as the software number.

They were read from Delphi DCM3.7 (3 files) control units.

Our catalogue lists them for the Ssangyong Stavic (2.0 155hp).

Other numbers on these files: 2 calibration / SW upgrade numbers (UCF52A30_D20DTR_A151AT5, UCF52A32_D20DTR_A150AT5).

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
UCF52A00
Files
3
Found as
software number
ECU types
1
Vehicles
1

ECU types with UCF52A00 1

Vehicles with UCF52A00 1

More Delphi DCM3.7 numbers 24

Need a modified file?

Tuning for Delphi DCM3.7 — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is UCF52A00 listed for?

In our catalogue: Ssangyong Stavic (2.0 155hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has UCF52A00?

In our catalogue UCF52A00 is on files read from Delphi DCM3.7 (3 files) control units.

There are several UCF52A00 files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.