RE503340 original ECU files
2 original (stock) ECU files with the hardware number RE503340 — Bosch, Phoenix L3, used in John Deere vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All RE503340 files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| SW001641 John Deere 84007.6 270hp · 6076HRW34 | Bosch | RE503340 | SW001641 | — | €20 · Open |
| SW50032A John Deere 84008.1 270hp · 6081HRW01 | Phoenix L3 | RE503340 | SW50032A | 6081047906 | €20 · Open |
No file in this list matches. Search all original files →
About RE503340
RE503340 is on 2 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Phoenix L3 (1 file) control units; the ECU model is not recorded for 1 file.
Our catalogue lists them for the John Deere 8400 (7.6 270hp, 8.1 270hp).
Other numbers on these files: 2 software numbers (SW001641, SW50032A); 1 calibration / SW upgrade number (6081047906), listed on 1 of the 2 files.
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- RE503340
- Files
- 2
- Found as
- hardware number
- ECU types
- 1
- Vehicles
- 1
ECU types with RE503340 1
Vehicles with RE503340 1
More Bosch numbers 1
Tuning for RE503340 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is RE503340 listed for?
In our catalogue: John Deere 8400 (7.6 270hp, 8.1 270hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has RE503340?
In our catalogue RE503340 is on files read from Phoenix L3 (1 file) control units; the ECU model is not recorded for 1 file.
There are several RE503340 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.