PEBA-18881-D original ECU files
2 original (stock) ECU files with the hardware number PEBA-18881-D — Denso E6T65xxx, Mitsubishi E6T65xxx, used in Mazda vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All PEBA-18881-D files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| PEBA-188K2-D Mazda CX-52.0 163hp | Denso E6T65xxx | PEBA-18881-D | PEBA-188K2-D | GGDS FNOS GE SPC | €20 · Open |
| PEBA-188K2-D Mazda CX-52.0 163hp | Mitsubishi E6T65xxx | PEBA-18881-D | PEBA-188K2-D | GGDS FNOS GE SPC | €20 · Open |
No file in this list matches. Search all original files →
About PEBA-18881-D
PEBA-18881-D is on 2 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Denso E6T65xxx (1 file) and Mitsubishi E6T65xxx (1 file) control units.
Our catalogue lists them for the Mazda CX-5 (2.0 163hp).
Other numbers on these files: 1 software number (PEBA-188K2-D).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- PEBA-18881-D
- Files
- 2
- Found as
- hardware number
- ECU types
- 2
- Vehicles
- 1
- Also written as
- PEBA18881D · PEBA 18881 D
ECU types with PEBA-18881-D 2
Vehicles with PEBA-18881-D 1
More Denso E6T65xxx numbers 1
Tuning for PEBA-18881-D — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is PEBA-18881-D listed for?
In our catalogue: Mazda CX-5 (2.0 163hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has PEBA-18881-D?
In our catalogue PEBA-18881-D is on files read from Denso E6T65xxx (1 file) and Mitsubishi E6T65xxx (1 file) control units.
There are several PEBA-18881-D files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.