Software number · 2 files

PE4J-18881-C original ECU files

2 original (stock) ECU files with the software number PE4J-18881-C — Denso PYBX, Denso SH725X, used in Mazda vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

2files
2ECU types
1models
1makes

All PE4J-18881-C files 2

VehicleECUHWSWCalibration / upgrade
PE4J-188K2-C Mazda CX-52.0 160hp Denso SH725X — PE4J-18881-C PE4J-18881-C PE4J-188K2-C €20 · Open
PE4A-188K1- Mazda CX-52.5 185hp Denso PYBX PE4A-188K1- PE4J-18881-C PE4J-188K2-C €20 · Open

About PE4J-18881-C

PE4J-18881-C is on 2 original (stock) ECU files in our catalogue: as the software number on 2 files and as the calibration on 1 file.

They were read from Denso SH725X (1 file) and Denso PYBX (1 file) control units.

Our catalogue lists them for the Mazda CX-5 (2.0 160hp, 2.5 185hp).

Other numbers on these files: 1 calibration / SW upgrade number (PE4J-188K2-C).

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
PE4J-18881-C
Files
2
Found as
software number and calibration
ECU types
2
Vehicles
1
Also written as
PE4J18881C · PE4J 18881 C

ECU types with PE4J-18881-C 2

Vehicles with PE4J-18881-C 1

More Denso PYBX numbers 1

Need a modified file?

Tuning for PE4J-18881-C — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is PE4J-18881-C listed for?

In our catalogue: Mazda CX-5 (2.0 160hp, 2.5 185hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has PE4J-18881-C?

In our catalogue PE4J-18881-C is on files read from Denso SH725X (1 file) and Denso PYBX (1 file) control units.

There are several PE4J-18881-C files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.