PE3B-188K2-H original ECU files
3 original (stock) ECU files with the hardware number PE3B-188K2-H — Mitsubishi E6T65xxx, Denso E6T65xxx, used in Mazda vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All PE3B-188K2-H files 3
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| Mazda CX-52.0 150hp | Mitsubishi E6T65xxx | PE3B-188K2-H | — | — | €20 · Open |
| Mazda CX-52.0 150hp | Denso E6T65xxx | PE3B-188K2-H | — | — | €20 · Open |
| Mazda CX-52.0 150hp | Mitsubishi E6T65xxx | PE3B-188K2-H | — | — | €20 · Open |
No file in this list matches. Search all original files →
About PE3B-188K2-H
PE3B-188K2-H is on 3 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Mitsubishi E6T65xxx (2 files) and Denso E6T65xxx (1 file) control units.
Our catalogue lists them for the Mazda CX-5 (2.0 150hp).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy. 2 of these files have the same numbers, ECU, vehicle and engine as another file in this list.
- Number
- PE3B-188K2-H
- Files
- 3
- Found as
- hardware number
- ECU types
- 2
- Vehicles
- 1
- Also written as
- PE3B188K2H · PE3B 188K2 H
ECU types with PE3B-188K2-H 2
Vehicles with PE3B-188K2-H 1
Tuning for PE3B-188K2-H — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is PE3B-188K2-H listed for?
In our catalogue: Mazda CX-5 (2.0 150hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has PE3B-188K2-H?
In our catalogue PE3B-188K2-H is on files read from Mitsubishi E6T65xxx (2 files) and Denso E6T65xxx (1 file) control units.
There are several PE3B-188K2-H files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.