LFJB-18881-B original ECU files
4 original (stock) ECU files with the software number LFJB-18881-B — Mitsubishi LFAS, used in Mazda vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All LFJB-18881-B files 4
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| Mazda 32.0 150hp | Mitsubishi LFAS | — | LFJB-18881-B | — | €20 · Open |
| Mazda 32.0 150hp | Mitsubishi LFAS | — | LFJB-18881-B | — | €20 · Open |
| Mazda 32.0 150hp | Mitsubishi LFAS | — | LFJB-18881-B | — | €20 · Open |
| Mazda 32.0 150hp | Mitsubishi LFAS | — | LFJB-18881-B | — | €20 · Open |
No file in this list matches. Search all original files →
About LFJB-18881-B
LFJB-18881-B is on 4 original (stock) ECU files in our catalogue, always as the software number.
They were read from Mitsubishi LFAS (4 files) control units.
Our catalogue lists them for the Mazda 3 (2.0 150hp).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy. 4 of these files have the same numbers, ECU, vehicle and engine as another file in this list.
- Number
- LFJB-18881-B
- Files
- 4
- Found as
- software number
- ECU types
- 1
- Vehicles
- 1
- Also written as
- LFJB18881B · LFJB 18881 B
ECU types with LFJB-18881-B 1
Vehicles with LFJB-18881-B 1
Tuning for Mitsubishi LFAS — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is LFJB-18881-B listed for?
In our catalogue: Mazda 3 (2.0 150hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has LFJB-18881-B?
In our catalogue LFJB-18881-B is on files read from Mitsubishi LFAS (4 files) control units.
There are several LFJB-18881-B files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.