L3TB021 original ECU files
5 original (stock) ECU files with the hardware number L3TB021 — Mitsubishi L3TB021, used in Mazda vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All L3TB021 files 5
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| Mazda CX-72.3 260hp | Mitsubishi L3TB021 | L3TB021 | — | — | €20 · Open |
| Mazda CX-72.3 260hp | Mitsubishi L3TB021 | L3TB021 | — | — | €20 · Open |
| Mazda CX-72.3 260hp | Mitsubishi L3TB021 | L3TB021 | — | — | €20 · Open |
| Mazda CX-72.3 260hp | Mitsubishi L3TB021 | L3TB021 | — | — | €20 · Open |
| L33PEU000 Mazda CX-72.3 260hp | Mitsubishi L3TB021 | L3TB021 | L33PEU000 | — | €20 · Open |
No file in this list matches. Search all original files →
About L3TB021
L3TB021 is on 5 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Mitsubishi L3TB021 (5 files) control units.
Our catalogue lists them for the Mazda CX-7 (2.3 260hp).
Other numbers on these files: 1 software number (L33PEU000), listed on 1 of the 5 files.
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy. 4 of these files have the same numbers, ECU, vehicle and engine as another file in this list.
- Number
- L3TB021
- Files
- 5
- Found as
- hardware number
- ECU types
- 1
- Vehicles
- 1
ECU types with L3TB021 1
Vehicles with L3TB021 1
Tuning for Mitsubishi L3TB021 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is L3TB021 listed for?
In our catalogue: Mazda CX-7 (2.3 260hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has L3TB021?
In our catalogue L3TB021 is on files read from Mitsubishi L3TB021 (5 files) control units.
There are several L3TB021 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.