BJ32-12K532-VSF original ECU files
2 original (stock) ECU files with the calibration BJ32-12K532-VSF — Bosch EDC17CP42, used in Land Rover vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All BJ32-12K532-VSF files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| Land Rover Range Rover Evoque2.2 190hp | Bosch EDC17CP42 | — | — | BJ32-12K532-VSF | €20 · Open |
| 1037513068 Land Rover Range Rover Evoque2.2 190hpMap pack · 176 maps | Bosch EDC17CP42 | — | 1037513068 | BJ32-12K532-VSF | €20 · OpenWith maps €60 |
No file in this list matches. Search all original files →
About BJ32-12K532-VSF
BJ32-12K532-VSF is on 2 original (stock) ECU files in our catalogue: as the calibration on 2 files and as the SW upgrade number on 2 files.
They were read from Bosch EDC17CP42 (2 files) control units.
Our catalogue lists them for the Land Rover Range Rover Evoque (2.2 190hp).
Other numbers on these files: 1 software number (1037513068), listed on 1 of the 2 files.
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- BJ32-12K532-VSF
- Files
- 2
- Found as
- calibration and SW upgrade number
- ECU types
- 1
- Vehicles
- 1
- Also written as
- BJ3212K532VSF · BJ32 12K532 VSF
ECU types with BJ32-12K532-VSF 1
Vehicles with BJ32-12K532-VSF 1
Tuning for Bosch EDC17CP42 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is BJ32-12K532-VSF listed for?
In our catalogue: Land Rover Range Rover Evoque (2.2 190hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has BJ32-12K532-VSF?
In our catalogue BJ32-12K532-VSF is on files read from Bosch EDC17CP42 (2 files) control units.
There are several BJ32-12K532-VSF files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.