8VD907115 original ECU files
2 original (stock) ECU files with the part number 8VD907115 — Bosch MG1CS001, used in Audi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 8VD907115 files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 10SW021892 8VD907115 0003 Audi A32.0 190hp | Bosch MG1CS001 | — | 10SW021892 | 8VD907115 0003 | €20 · Open |
| 10SW021892 8VD907115 0004 Audi A52.0 190hp | Bosch MG1CS001 | — | 10SW021892 | 8VD907115 0004 | €20 · Open |
No file in this list matches. Search all original files →
About 8VD907115
8VD907115 is on 2 original (stock) ECU files in our catalogue, always as the calibration.
They were read from Bosch MG1CS001 (2 files) control units.
Our catalogue lists them for the Audi A3 (2.0 190hp) and Audi A5 (2.0 190hp).
Other numbers on these files: 1 software number (10SW021892).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 8VD907115
- Files
- 2
- Found as
- calibration
- ECU types
- 1
- Vehicles
- 2
- Also written as
- 8VD 907 115
ECU types with 8VD907115 1
Vehicles with 8VD907115 2
More Bosch MG1CS001 numbers 18
Tuning for Bosch MG1CS001 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 8VD907115 listed for?
In our catalogue: Audi A3 (2.0 190hp) and Audi A5 (2.0 190hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 8VD907115?
In our catalogue 8VD907115 is on files read from Bosch MG1CS001 (2 files) control units.
There are several 8VD907115 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.