8R0927156AC original ECU files
2 original (stock) ECU files with the part number 8R0927156AC — Temic DL501, Temic DL501 GEN2, used in Audi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 8R0927156AC files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 8R0927156AC 0004 Audi Q53.0 240hp | Temic DL501 GEN2 | — | — | 8R0927156AC 0004 | €20 · Open |
| 0B5927156E A02087 Audi S43.0 333hp · CEPA | Temic DL501 | 0B5927156E | A02087 | 8R0927156AC 0003 | €20 · Open |
No file in this list matches. Search all original files →
About 8R0927156AC
8R0927156AC is on 2 original (stock) ECU files in our catalogue: as the calibration on 2 files and as the SW upgrade number on 2 files.
They were read from Temic DL501 GEN2 (1 file) and Temic DL501 (1 file) control units.
Our catalogue lists them for the Audi Q5 (3.0 240hp) and Audi S4 (3.0 333hp).
Other numbers on these files: 1 hardware number (0B5927156E), listed on 1 of the 2 files; 1 software number (A02087), listed on 1 of the 2 files.
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 8R0927156AC
- Files
- 2
- Found as
- calibration and SW upgrade number
- ECU types
- 2
- Vehicles
- 2
- Also written as
- 8R0 927 156 AC
ECU types with 8R0927156AC 2
Vehicles with 8R0927156AC 2
Tuning for 8R0927156AC — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 8R0927156AC listed for?
In our catalogue: Audi Q5 (3.0 240hp) and Audi S4 (3.0 333hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 8R0927156AC?
In our catalogue 8R0927156AC is on files read from Temic DL501 GEN2 (1 file) and Temic DL501 (1 file) control units.
There are several 8R0927156AC files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.