89661-3F360 original ECU files
3 original (stock) ECU files with the hardware number 89661-3F360 — Denso GEN1, used in Toyota vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 89661-3F360 files 3
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 89663-30151 Toyota Crown4.3 300hp · 3UZ-FE | Denso GEN1 | 89661-3F360 | 89663-30151 | 33015100 | €20 · Open |
| 89663-30571 Toyota Crown4.3 300hp · 3UZ-FE | Denso GEN1 | 89661-3F360 | 89663-30571 | 33057100 | €20 · Open |
| 89663-50762 Toyota Crown4.3 300hp · 3UZ-FE | Denso GEN1 | 89661-3F360 | 89663-50762 | 35076200 | €20 · Open |
No file in this list matches. Search all original files →
About 89661-3F360
89661-3F360 is on 3 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Denso GEN1 (3 files) control units.
Our catalogue lists them for the Toyota Crown (4.3 300hp).
Other numbers on these files: 3 software numbers (89663-30151, 89663-30571, 89663-50762); 3 calibration / SW upgrade numbers (33015100, 33057100, 35076200).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 89661-3F360
- Files
- 3
- Found as
- hardware number
- ECU types
- 1
- Vehicles
- 1
- Also written as
- 896613F360 · 89661 3F360
ECU types with 89661-3F360 1
Vehicles with 89661-3F360 1
Tuning for Denso GEN1 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 89661-3F360 listed for?
In our catalogue: Toyota Crown (4.3 300hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 89661-3F360?
In our catalogue 89661-3F360 is on files read from Denso GEN1 (3 files) control units.
There are several 89661-3F360 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.