Part number · 2 files

5NA907115J original ECU files

2 original (stock) ECU files with the part number 5NA907115J — Bosch MG1CS111, used in Skoda, Volkswagen vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

2files
1ECU types
2models
2makes

All 5NA907115J files 2

VehicleECUHWSWCalibration / upgrade
5NA907115J 0001 Skoda Kodiak2.0 190hpMap pack · 180 maps Bosch MG1CS111 — — 5NA907115J 0001 €20 · OpenWith maps €70
5NA907115J 0002 Volkswagen Polo2.0 200hp Bosch MG1CS111 5NA907115J 0002 5NA907115J 0002 €20 · Open

About 5NA907115J

5NA907115J is on 2 original (stock) ECU files in our catalogue: as the calibration on 2 files, as the hardware number on 1 file and as the SW upgrade number on 1 file.

They were read from Bosch MG1CS111 (2 files) control units.

Our catalogue lists them for the Skoda Kodiak (2.0 190hp) and Volkswagen Polo (2.0 200hp).

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
5NA907115J
Files
2
Found as
calibration, hardware number and SW upgrade number
ECU types
1
Vehicles
2
Also written as
5NA 907 115 J

ECU types with 5NA907115J 1

Vehicles with 5NA907115J 2

More Bosch MG1CS111 numbers 12

Need a modified file?

Tuning for Bosch MG1CS111 — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is 5NA907115J listed for?

In our catalogue: Skoda Kodiak (2.0 190hp) and Volkswagen Polo (2.0 200hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has 5NA907115J?

In our catalogue 5NA907115J is on files read from Bosch MG1CS111 (2 files) control units.

There are several 5NA907115J files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.