4F9910401J original ECU files
2 original (stock) ECU files with the hardware number 4F9910401J — Bosch EDC16CP34, used in Audi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 4F9910401J files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 4F9910401J 0010 Audi A43.0 TDI V6 232hp | Bosch EDC16CP34 | 4F9910401J | 0010 | 4F9910401J-0010 | €20 · Open |
| 4F9910401J 0020 Audi A63.0 233hp | Bosch EDC16CP34 | 4F9910401J | 0020 | 4F9910401J 0020 | €20 · Open |
No file in this list matches. Search all original files →
About 4F9910401J
4F9910401J is on 2 original (stock) ECU files in our catalogue: as the hardware number on 2 files, as the SW upgrade number on 1 file and as the calibration on 1 file.
They were read from Bosch EDC16CP34 (2 files) control units.
Our catalogue lists them for the Audi A4 (3.0 TDI V6 232hp) and Audi A6 (3.0 233hp).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 4F9910401J
- Files
- 2
- Found as
- hardware number, SW upgrade number and calibration
- ECU types
- 1
- Vehicles
- 2
- Also written as
- 4F9 910 401 J
ECU types with 4F9910401J 1
Vehicles with 4F9910401J 2
More Bosch EDC16CP34 numbers 24
Tuning for Bosch EDC16CP34 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 4F9910401J listed for?
In our catalogue: Audi A4 (3.0 TDI V6 232hp) and Audi A6 (3.0 233hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 4F9910401J?
In our catalogue 4F9910401J is on files read from Bosch EDC16CP34 (2 files) control units.
There are several 4F9910401J files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.