30E29200 original ECU files
2 original (stock) ECU files with the calibration 30E29200 — Denso D76F019XXX, used in Toyota vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 30E29200 files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 89663-0E292 Toyota Highlander2.0 238hp | Denso D76F019XXX | — | 89663-0E292 | 30E29200 | €20 · Open |
| 89663-0E292-A Toyota Highlander2.0 238hp | Denso D76F019XXX | — | 89663-0E292-A | 30E29200 | €20 · Open |
No file in this list matches. Search all original files →
About 30E29200
30E29200 is on 2 original (stock) ECU files in our catalogue: as the calibration on 2 files and as the SW upgrade number on 2 files.
They were read from Denso D76F019XXX (2 files) control units.
Our catalogue lists them for the Toyota Highlander (2.0 238hp).
Other numbers on these files: 2 software numbers (89663-0E292, 89663-0E292-A).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 30E29200
- Files
- 2
- Found as
- calibration and SW upgrade number
- ECU types
- 1
- Vehicles
- 1
ECU types with 30E29200 1
Vehicles with 30E29200 1
Tuning for Denso D76F019XXX — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 30E29200 listed for?
In our catalogue: Toyota Highlander (2.0 238hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 30E29200?
In our catalogue 30E29200 is on files read from Denso D76F019XXX (2 files) control units.
There are several 30E29200 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.