1860A981 original ECU files
3 original (stock) ECU files with the hardware number 1860A981 — Mitsubishi 53040013, Mitsubishi 53040010, Mitsubishi E6T7xxxx, used in Mitsubishi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 1860A981 files 3
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 53040010 Mitsubishi Lancer2.0 296hp | Mitsubishi 53040010 | 1860A981 | 53040010 | — | €20 · Open |
| 53040013 Mitsubishi Lancer2.0 296hp | Mitsubishi 53040013 | 1860A981 | 53040013 | — | €20 · Open |
| 53040007 Mitsubishi Lancer2.0 T 296hp | Mitsubishi E6T7xxxx | 1860A981 | 53040007 | — | €20 · Open |
No file in this list matches. Search all original files →
About 1860A981
1860A981 is on 3 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Mitsubishi 53040010 (1 file), Mitsubishi 53040013 (1 file) and Mitsubishi E6T7xxxx (1 file) control units.
Our catalogue lists them for the Mitsubishi Lancer (2.0 T 296hp).
Other numbers on these files: 3 software numbers (53040010, 53040013, 53040007).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 1860A981
- Files
- 3
- Found as
- hardware number
- ECU types
- 3
- Vehicles
- 1
ECU types with 1860A981 3
Vehicles with 1860A981 1
Tuning for 1860A981 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 1860A981 listed for?
In our catalogue: Mitsubishi Lancer (2.0 T 296hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 1860A981?
In our catalogue 1860A981 is on files read from Mitsubishi 53040010 (1 file), Mitsubishi 53040013 (1 file) and Mitsubishi E6T7xxxx (1 file) control units.
There are several 1860A981 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.