10SW030489 original ECU files
3 original (stock) ECU files with the software number 10SW030489 — Bosch MED17.9.64, Bosch ME17.9.64, used in Suzuki vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 10SW030489 files 3
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| Suzuki Ignis1.2 90hp | Bosch MED17.9.64 | 0261XXXXXX | 10SW030489 | — | €20 · Open |
| Suzuki Ignis1.2 90hp | Bosch ME17.9.64 | — | 10SW030489 | 10SW030489 | €20 · Open |
| Suzuki Jimny1.5 100hp | Bosch MED17.9.64 | 0261XXXXXX | 10SW030489 | — | €20 · Open |
No file in this list matches. Search all original files →
About 10SW030489
10SW030489 is on 3 original (stock) ECU files in our catalogue: as the software number on 3 files and as the calibration on 1 file.
They were read from Bosch MED17.9.64 (2 files) and Bosch ME17.9.64 (1 file) control units.
Our catalogue lists them for the Suzuki Ignis (1.2 90hp) and Suzuki Jimny (1.5 100hp).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 10SW030489
- Files
- 3
- Found as
- software number and calibration
- ECU types
- 2
- Vehicles
- 2
ECU types with 10SW030489 2
Vehicles with 10SW030489 2
Tuning for 10SW030489 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 10SW030489 listed for?
In our catalogue: Suzuki Ignis (1.2 90hp) and Suzuki Jimny (1.5 100hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 10SW030489?
In our catalogue 10SW030489 is on files read from Bosch MED17.9.64 (2 files) and Bosch ME17.9.64 (1 file) control units.
There are several 10SW030489 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.