07K906055DK original ECU files
2 original (stock) ECU files with the part number 07K906055DK — Bosch ME17.5.6, used in Volkswagen vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 07K906055DK files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 0261S06176 1037524463 Volkswagen Passat 72.5 20v 170hp · CBTA | Bosch ME17.5.6 | 0261S06176 | 1037524463 | 07K906055DK 4334 | €20 · Open |
| 07K906055DK 4733 Volkswagen Vento2.5 170hp · CBTA | Bosch ME17.5.6 | — | — | 07K906055DK 4733 | €20 · Open |
No file in this list matches. Search all original files →
About 07K906055DK
07K906055DK is on 2 original (stock) ECU files in our catalogue: as the calibration on 2 files and as the SW upgrade number on 2 files.
They were read from Bosch ME17.5.6 (2 files) control units.
Our catalogue lists them for the Volkswagen Passat 7 (2.5 20v 170hp) and Volkswagen Vento (2.5 170hp).
Other numbers on these files: 1 hardware number (0261S06176), listed on 1 of the 2 files; 1 software number (1037524463), listed on 1 of the 2 files.
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 07K906055DK
- Files
- 2
- Found as
- calibration and SW upgrade number
- ECU types
- 1
- Vehicles
- 2
- Also written as
- 07K 906 055 DK
ECU types with 07K906055DK 1
Vehicles with 07K906055DK 2
Tuning for Bosch ME17.5.6 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 07K906055DK listed for?
In our catalogue: Volkswagen Passat 7 (2.5 20v 170hp) and Volkswagen Vento (2.5 170hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 07K906055DK?
In our catalogue 07K906055DK is on files read from Bosch ME17.5.6 (2 files) control units.
There are several 07K906055DK files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.