06A906033BD original ECU files
2 original (stock) ECU files with the part number 06A906033BD — Siemens SIMOS3.03, Siemens SIMOS3.3, used in Audi, Skoda vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 06A906033BD files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 06A906033BD 4582 Audi A31.6 8V 102hp | Siemens SIMOS3.03 | — | — | 06A906033BD 4582 | €20 · Open |
| 06A906033BD 6159 Skoda Octavia1.6 8V 102hp | Siemens SIMOS3.3 | 06A906033BD | 6159 | 06A906033BD 6159 | €20 · Open |
No file in this list matches. Search all original files →
About 06A906033BD
06A906033BD is on 2 original (stock) ECU files in our catalogue: as the calibration on 2 files, as the SW upgrade number on 2 files and as the hardware number on 1 file.
They were read from Siemens SIMOS3.03 (1 file) and Siemens SIMOS3.3 (1 file) control units.
Our catalogue lists them for the Audi A3 (1.6 8V 102hp) and Skoda Octavia (1.6 8V 102hp).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 06A906033BD
- Files
- 2
- Found as
- calibration, SW upgrade number and hardware number
- ECU types
- 2
- Vehicles
- 2
- Also written as
- 06A 906 033 BD
ECU types with 06A906033BD 2
Vehicles with 06A906033BD 2
More Siemens SIMOS3.03 numbers 1
Tuning for 06A906033BD — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 06A906033BD listed for?
In our catalogue: Audi A3 (1.6 8V 102hp) and Skoda Octavia (1.6 8V 102hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 06A906033BD?
In our catalogue 06A906033BD is on files read from Siemens SIMOS3.03 (1 file) and Siemens SIMOS3.3 (1 file) control units.
There are several 06A906033BD files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.