04E906027AL original ECU files
3 original (stock) ECU files with the part number 04E906027AL — Bosch MED17.5.25, used in Audi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 04E906027AL files 3
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 04E906027AL 0826 Audi A11.4 125hp · CZCA | Bosch MED17.5.25 | — | — | 04E906027AL 0826 | €20 · Open |
| 04E906027AL 4697 Audi A11.4 125hp · CZCAMap pack · 135 maps | Bosch MED17.5.25 | — | — | 04E906027AL 4697 | €20 · OpenWith maps €70 |
| 1037553700 04E906027AL 2118 Audi A11.4 125hp · CZCA | Bosch MED17.5.25 | 0261xxxxxxx | 1037553700 | 04E906027AL 2118 | €20 · Open |
No file in this list matches. Search all original files →
About 04E906027AL
04E906027AL is on 3 original (stock) ECU files in our catalogue: as the calibration on 3 files and as the SW upgrade number on 3 files.
They were read from Bosch MED17.5.25 (3 files) control units.
Our catalogue lists them for the Audi A1 (1.4 125hp).
Other numbers on these files: 1 software number (1037553700), listed on 1 of the 3 files.
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 04E906027AL
- Files
- 3
- Found as
- calibration and SW upgrade number
- ECU types
- 1
- Vehicles
- 1
- Also written as
- 04E 906 027 AL
ECU types with 04E906027AL 1
Vehicles with 04E906027AL 1
Tuning for Bosch MED17.5.25 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 04E906027AL listed for?
In our catalogue: Audi A1 (1.4 125hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 04E906027AL?
In our catalogue 04E906027AL is on files read from Bosch MED17.5.25 (3 files) control units.
There are several 04E906027AL files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.