03P906021E original ECU files
3 original (stock) ECU files with the hardware number 03P906021E — Delphi DCM3.7, used in Volkswagen vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 03P906021E files 3
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 03P906021E 9509 Volkswagen Polo1.2 75hp · CFWA | Delphi DCM3.7 | 03P906021E | 9509 | 03P906021E 9509 | €20 · Open |
| 03P906021E 9709 Volkswagen Polo1.2 75hp | Delphi DCM3.7 | 03P906021E | 9709 | 03P906021E 9709 | €20 · Open |
| 03P906021E 9979 Volkswagen Polo1.2 75hp | Delphi DCM3.7 | 03P906021E | 9979 | 03P906021E 9979 | €20 · Open |
No file in this list matches. Search all original files →
About 03P906021E
03P906021E is on 3 original (stock) ECU files in our catalogue: as the calibration on 3 files, as the SW upgrade number on 3 files and as the hardware number on 3 files.
They were read from Delphi DCM3.7 (3 files) control units.
Our catalogue lists them for the Volkswagen Polo (1.2 75hp).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 03P906021E
- Files
- 3
- Found as
- calibration, SW upgrade number and hardware number
- ECU types
- 1
- Vehicles
- 1
- Also written as
- 03P 906 021 E
ECU types with 03P906021E 1
Vehicles with 03P906021E 1
Tuning for Delphi DCM3.7 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 03P906021E listed for?
In our catalogue: Volkswagen Polo (1.2 75hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 03P906021E?
In our catalogue 03P906021E is on files read from Delphi DCM3.7 (3 files) control units.
There are several 03P906021E files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.