Part number · 2 files

03H906026J original ECU files

2 original (stock) ECU files with the part number 03H906026J — Bosch MED17.1.62, used in Volkswagen vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.

2files
1ECU types
2models
1makes

All 03H906026J files 2

VehicleECUHWSWCalibration / upgrade
03H906026J 6026 Volkswagen Atlas2.0 280hp Bosch MED17.1.62 — — 03H906026J 6026 €20 · Open
03H906026J 4748 Volkswagen Teramont3.6 250hp Bosch MED17.1.62 03H906026J 4748 03H906026J 4748 €20 · Open

About 03H906026J

03H906026J is on 2 original (stock) ECU files in our catalogue: as the SW upgrade number on 2 files, as the calibration on 2 files and as the hardware number on 1 file.

They were read from Bosch MED17.1.62 (2 files) control units.

Our catalogue lists them for the Volkswagen Atlas (2.0 280hp) and Volkswagen Teramont (3.6 250hp).

To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.

Number
03H906026J
Files
2
Found as
SW upgrade number, calibration and hardware number
ECU types
1
Vehicles
2
Also written as
03H 906 026 J

ECU types with 03H906026J 1

Vehicles with 03H906026J 2

More Bosch MED17.1.62 numbers 15

Need a modified file?

Tuning for Bosch MED17.1.62 — done by our engineers

  • Stage 1 / Stage 2 / ECO
  • DPF / FAP OFF
  • EGR OFF
  • AdBlue / SCR OFF
  • DTC OFF
  • Speed limiter, Start&Stop

Questions

Which vehicles is 03H906026J listed for?

In our catalogue: Volkswagen Atlas (2.0 280hp) and Volkswagen Teramont (3.6 250hp). Open the file page that matches your vehicle, engine and numbers.

Which ECU has 03H906026J?

In our catalogue 03H906026J is on files read from Bosch MED17.1.62 (2 files) control units.

There are several 03H906026J files. Which one do I need?

The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.

How do I get the file?

Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.

What exactly do I receive?

The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.