0261208051 original ECU files
2 original (stock) ECU files with the hardware number 0261208051 — Bosch ME7.1.1, used in Audi vehicles. The other numbers (software, calibration) tell these files apart: compare them with your own read and open the matching file.
All 0261208051 files 2
| Vehicle | ECU | HW | SW | Calibration / upgrade | |
|---|---|---|---|---|---|
| 1037366111 4D1907558B 0001 Audi RS64.2 V8 450hp | Bosch ME7.1.1 | 0261208051 | 1037366111 | 4D1907558B 0001 | €20 · Open |
| 1037368087 4D1907558B 0002 Audi RS64.2 V8 BITURBO 450hp | Bosch ME7.1.1 | 0261208051 | 1037368087 | 4D1907558B 0002 | €20 · Open |
No file in this list matches. Search all original files →
About 0261208051
0261208051 is on 2 original (stock) ECU files in our catalogue, always as the hardware number.
They were read from Bosch ME7.1.1 (2 files) control units.
Our catalogue lists them for the Audi RS6 (4.2 V8 Biturbo 450hp).
Other numbers on these files: 2 software numbers (1037366111, 1037368087); 2 calibration / SW upgrade numbers (4D1907558B_0001, 4D1907558B_0002).
To choose, compare every number of your own read — HW, SW, calibration and SW upgrade where listed — with each file page before you buy.
- Number
- 0261208051
- Files
- 2
- Found as
- hardware number
- ECU types
- 1
- Vehicles
- 1
- Also written as
- 0 261 208 051
ECU types with 0261208051 1
Vehicles with 0261208051 1
Tuning for Bosch ME7.1.1 — done by our engineers
- Stage 1 / Stage 2 / ECO
- DPF / FAP OFF
- EGR OFF
- AdBlue / SCR OFF
- DTC OFF
- Speed limiter, Start&Stop
Questions
Which vehicles is 0261208051 listed for?
In our catalogue: Audi RS6 (4.2 V8 Biturbo 450hp). Open the file page that matches your vehicle, engine and numbers.
Which ECU has 0261208051?
In our catalogue 0261208051 is on files read from Bosch ME7.1.1 (2 files) control units.
There are several 0261208051 files. Which one do I need?
The one whose numbers match your own read: compare HW, SW, calibration and SW upgrade where they are listed on the file page. All sales are final, so check before you buy.
How do I get the file?
Open the file page and use Quick buy: €20 by card, no registration. We request the file from the original-file database and e-mail it to you — usually within minutes, normally within 24 hours. With an account on our file service fs.auto-remap.com you can also top up your balance and order there.
What exactly do I receive?
The original read only, as a ready-to-use .bin file (ordered through a file-service account: a ZIP archive with an .ori file inside). No full backups, EPROMs, SGO, VBF or other formats. Different tools expect different file sizes when writing, so make sure the file suits your device. All sales are final: check HW and SW against your own read before you buy.