10SW047293 2G0907115A 0003 Bosch MG1CS111 WinOLS mappack
Volkswagen Polo
- One ZIP by e-mail: the original .bin + the .csv mappack for WinOLS — it imports just like a .kp map pack
- Maps with correctly labelled X and Y axes in the right format and the correct factor for the data values
- Every map of the export is included — each map's name is listed below
- Axes checked against this exact original for all 268 maps
- No account — your e-mail and a card
- Check the HW / SW above against your read — all sales are final
E-mailed usually within a minute · your card is charged only when the ZIP is ready
Engine Torque 67 maps
- Limiter of Maximum torque 17 maps
- Limiter of Maximum torque in case of system error 9 maps
- Maximum engine torque correction f(ECT_T)
- Maximum power limiter
- Maximum torque limiter f(gear)
- Optimal engine torque
- Torque monitoring 4 maps
- Torque request during take off condition 33 maps
Spark Advance 50 maps
- Limiter of knocking sensor 5 maps
- Minimum Spark Advance 13 maps
- Optimal Spark Advance 16 maps
- Spark Advance base map 16 maps
Limiters 49 maps
- Maximum speed of vehicle 8 maps
- RPM Limiter 40 maps
- RPM limiter in Neutral
Turbo System 24 maps
- Ambient pressure threshold for charge pressure diagnostics
- Compressor efficiency
- Correction of turbo pressure f(IAT)
- Limiter of Turbo pressure 3 maps
- Limiter of Turbo pressure f(IAT) 6 maps
- Maximum turbocharger speed 2 maps
- Turbine efficiency 2 maps
- Turbo pressure 4 maps
- Wastegate Duty Cycle 4 maps
Variable Valve Timing (VVT) 24 maps
- Exhaust 9 maps
- Intake 15 maps
Injection System 21 maps
- Injection correction 10 maps
- Injection enrichment 3 maps
- Lambda for component protection 7 maps
- Requested Lambda
Air Control 18 maps
- Airflow mass through throttle valve
- Engine load limiter 5 maps
- Exhaust gas temperature 6 maps
- MAF sensor slope 3 maps
- Requested engine load
- Throttle valve - operating angle
- Volumetric efficiency
Deactivations 8 maps
- Catalytic converter Diagnosis (1=ON, 0=OFF)
- Lambda Sensor (1=ON, 0=OFF) 7 maps
Rail 6 maps
- Rail pressure 4 maps
- Rail pressure limiter
- Rail pressure limiter f(RPM,Fuel_T)
Launch Control 1 map
- RPM limiter
Is this my file?
Compare these numbers with your ECU read: this map pack is made for this software version.
- SW
- 10SW047293
- CAL
- 2G0907115A 0003
- Vehicle
- Volkswagen Polo 2.0 200hp
- ECU
- Bosch MG1CS111
Not your software version? Other versions of 2G0907115A 2
| Version | Vehicle | |
|---|---|---|
| CAL 2G0907115A 0004 | Volkswagen Polo2.0 220hp | Map pack · 220 maps · €70 |
| CAL 2G0907115A 0001 | Skoda Kodiaq2.0 190hp | Map pack · 259 maps · €70 |
Example map from this packLambda for component protection · 12 × 16 · read from this very original
Lambda for component protection
12 × 16 · X axis: Air charge, % · Y axis: Engine speed, rpm · values in lambda
| % →rpm ↓ | 10 | 15 | 19 | 30 | 40 | 60 | 80 | 100 | 115 | 130 | 145 | 175 |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 500 | 1.30 | 1.30 | 1.30 | 1.30 | 1.30 | 1.31 | 1.23 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 |
| 720 | 1.30 | 1.30 | 1.30 | 1.30 | 1.30 | 1.31 | 1.23 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 |
| 1000 | 1.30 | 1.30 | 1.30 | 1.30 | 1.30 | 1.31 | 1.23 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 |
| 1240 | 1.30 | 1.30 | 1.30 | 1.30 | 1.30 | 1.31 | 1.23 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 |
| 1520 | 1.30 | 1.30 | 1.30 | 1.30 | 1.30 | 1.31 | 1.23 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 |
| 1760 | 1.25 | 1.25 | 1.25 | 1.25 | 1.25 | 1.25 | 1.17 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 |
| 2000 | 1.21 | 1.21 | 1.21 | 1.21 | 1.21 | 1.21 | 1.16 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 |
| 2520 | 1.18 | 1.18 | 1.18 | 1.18 | 1.16 | 1.17 | 1.13 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 |
| 3000 | 1.16 | 1.16 | 1.16 | 1.16 | 1.06 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 |
| 3520 | 1.04 | 1.04 | 1.04 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 0.97 | 0.96 |
| 4000 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 0.96 | 0.96 | 0.94 |
| 4520 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 0.95 | 0.93 | 0.93 |
| 5000 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 0.98 | 0.94 | 0.94 | 0.92 |
| 5520 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 0.98 | 0.96 | 0.93 | 0.92 | 0.89 |
| 6000 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 0.96 | 0.94 | 0.90 | 0.90 | 0.88 |
| 6500 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 1.00 | 0.98 | 0.95 | 0.93 | 0.90 | 0.89 | 0.87 |
Swipe the table sideways to see every column.
One of 268 maps in this pack, read from this original file. Every other map is named in the list above.
What you get
What is in our map packs. Maps with correctly labelled X and Y axes in the right format and the correct factor for the data values, ready to read. Every map of the export is included, listed by category — you see each map's name before you buy.
Questions
What is a WinOLS mappack?
The definitions of the maps in one ECU software version — name, category, size, axes and position — exported from WinOLS as a CSV. It is not a DAMOS or A2L file and holds no tuned values.
Will it fit my ECU?
It is made for this software version: compare the HW / SW numbers above with your read.
Why €70?
Our map-pack prices, the original file included: cars €60 when the ECU type came out before 2012, €70 from 2012 on; motorcycles and boats €80; trucks and agricultural machinery €90.
Refunds?
All sales are final — check the numbers and the map list before you buy.
All Volkswagen Polo map packs · All Bosch MG1CS111 mappacks · Search all mappacks