0261S02721 1037501227 8P0907115AP 0010 Bosch MED9.1 WinOLS mappack
Audi S3
- One ZIP by e-mail: the original .bin + the .csv mappack for WinOLS — it imports just like a .kp map pack
- Maps with correctly labelled X and Y axes in the right format and the correct factor for the data values
- Every map of the export is included — each map's name is listed below
- Axes checked against this exact original for all 161 maps
- No account — your e-mail and a card
- Check the HW / SW above against your read — all sales are final
E-mailed usually within a minute · your card is charged only when the ZIP is ready
Engine Torque 33 maps
- Calculated engine torque 9 maps
- Desired torque at wheel
- Engine torque correction
- Limiter of Maximum torque
- Optimal engine torque 2 maps
- Torque limiter for clutch protection
- Torque monitoring 12 maps
- Torque request during take off condition - Fifth Gear
- Torque request during take off condition - First Gear
- Torque request during take off condition - Forth Gear
- Torque request during take off condition - Reverse Gear
- Torque request during take off condition - Second Gear
- Torque request during take off condition - Third Gear
Turbo System 32 maps
- Correction of impulsive turbo pressure f(IAT) 3 maps
- Correction of slow incremental factor of turbo pressure
- Correction of steady turbo pressure f(IAT) 3 maps
- Correction of turbo pressure 2 maps
- Correction of turbo pressure f(IAT) 4 maps
- Fast reduction factor of turbo pressure
- Limiter of Turbo pressure 6 maps
- Limiter of Turbo pressure f(APS)
- Limiter of Turbo pressure f(IAT)
- Limiter of impulsive turbo pressure 3 maps
- Limiter of steady turbo pressure 3 maps
- Linearization of impulsive turbo pressure
- Slow incremental factor of turbo pressure
- Turbo pressure 2 maps
Spark Advance 29 maps
- Limiter of knocking sensor 4 maps
- Minimum Spark Advance 12 maps
- Optimal Spark Advance 2 maps
- Spark Advance base map 6 maps
- Spark advance correction f(Trq) 2 maps
- Spark advance during cranking 3 maps
Injection System 17 maps
- Injection base map
- Injection correction 6 maps
- Injection enrichment
- Limiter of Lambda A 3 maps
- Limiter of Lambda B 3 maps
- Requested Lambda 3 maps
Limiters 14 maps
- Maximum speed of vehicle 8 maps
- RPM Limiter 4 maps
- RPM limiter (higher threshold) 2 maps
Air Control 13 maps
- Airflow mass through throttle valve 2 maps
- Engine load limiter 4 maps
- Exhaust gas temperature 3 maps
- Requested engine load
- Threshold of end limitation on throttle valve angle
- Throttle valve - operating angle
- Throttle valve f(Accelerator pedal)
Variable Valve Timing (VVT) 10 maps
- Intake 10 maps
Rail 7 maps
- Rail pressure 5 maps
- Rail pressure limiter f(RPM,Fuel_Q)
- Rail pressure limiter f(RPM,Fuel_T)
Deactivations 6 maps
- Catalytic converter Diagnosis (1=ON, 0=OFF) 2 maps
- Lambda Sensor (1=ON, 0=OFF) 4 maps
Is this my file?
Compare these numbers with your ECU read: this map pack is made for this software version.
- HW
- 0261S02721
- SW
- 1037501227
- CAL
- 8P0907115AP 0010
- Vehicle
- Audi S3 2.0 265hp
- ECU
- Bosch MED9.1
Example map from this packOptimal engine torque · 11 × 16 · read from this very original
Optimal engine torque
11 × 16 · X axis: Air charge, % · Y axis: Engine speed, rpm · values in %
| % →rpm ↓ | 10 | 15 | 20 | 35 | 50 | 65 | 80 | 100 | 120 | 150 | 180 |
|---|---|---|---|---|---|---|---|---|---|---|---|
| 500 | 3.33 | 5.66 | 8.02 | 15.08 | 22.16 | 29.22 | 36.23 | 45.46 | 54.50 | 67.81 | 81.03 |
| 700 | 3.57 | 5.87 | 8.18 | 15.13 | 22.24 | 29.35 | 36.47 | 45.72 | 54.70 | 67.92 | 81.06 |
| 800 | 3.68 | 5.97 | 8.27 | 15.16 | 22.28 | 29.41 | 36.58 | 45.85 | 54.80 | 67.98 | 81.08 |
| 1000 | 3.90 | 6.18 | 8.46 | 15.23 | 22.37 | 29.52 | 36.80 | 46.09 | 54.99 | 68.10 | 81.12 |
| 1240 | 4.14 | 6.40 | 8.67 | 15.47 | 22.51 | 29.59 | 36.96 | 46.33 | 55.22 | 68.25 | 81.19 |
| 1520 | 4.32 | 6.60 | 8.89 | 15.77 | 22.77 | 29.86 | 37.11 | 46.53 | 55.51 | 68.47 | 81.32 |
| 2000 | 4.52 | 6.85 | 9.19 | 16.21 | 23.22 | 30.34 | 37.55 | 47.06 | 56.14 | 68.95 | 81.67 |
| 2520 | 4.65 | 7.03 | 9.41 | 16.54 | 23.63 | 30.80 | 38.13 | 47.86 | 57.04 | 69.75 | 82.31 |
| 3000 | 4.71 | 7.13 | 9.55 | 16.77 | 23.96 | 31.24 | 38.72 | 48.63 | 57.91 | 70.70 | 83.16 |
| 3520 | 4.73 | 7.18 | 9.64 | 16.98 | 24.33 | 31.80 | 39.38 | 49.32 | 58.66 | 71.62 | 84.12 |
| 4000 | 4.73 | 7.21 | 9.70 | 17.16 | 24.68 | 32.29 | 39.92 | 49.83 | 59.19 | 72.29 | 84.89 |
| 4520 | 4.75 | 7.26 | 9.79 | 17.36 | 25.01 | 32.70 | 40.34 | 50.20 | 59.54 | 72.72 | 85.43 |
| 5000 | 4.80 | 7.34 | 9.90 | 17.57 | 25.29 | 33.00 | 40.60 | 50.37 | 59.61 | 72.77 | 85.55 |
| 5520 | 4.90 | 7.47 | 10.06 | 17.80 | 25.56 | 33.27 | 40.82 | 50.44 | 59.48 | 72.51 | 85.30 |
| 6000 | 5.01 | 7.61 | 10.22 | 18.03 | 25.82 | 33.51 | 41.00 | 50.41 | 59.20 | 71.99 | 84.80 |
| 6520 | 5.15 | 7.78 | 10.42 | 18.30 | 26.12 | 33.78 | 41.15 | 50.30 | 58.79 | 71.20 | 84.13 |
Swipe the table sideways to see every column.
One of 161 maps in this pack, read from this original file. Every other map is named in the list above.
What you get
What is in our map packs. Maps with correctly labelled X and Y axes in the right format and the correct factor for the data values, ready to read. Every map of the export is included, listed by category — you see each map's name before you buy.
Questions
What is a WinOLS mappack?
The definitions of the maps in one ECU software version — name, category, size, axes and position — exported from WinOLS as a CSV. It is not a DAMOS or A2L file and holds no tuned values.
Will it fit my ECU?
It is made for this software version: compare the HW / SW numbers above with your read.
Why €60?
Our map-pack prices, the original file included: cars €60 when the ECU type came out before 2012, €70 from 2012 on; motorcycles and boats €80; trucks and agricultural machinery €90.
Refunds?
All sales are final — check the numbers and the map list before you buy.
All Audi S3 map packs · All Bosch MED9.1 mappacks · This original file · Search all mappacks