Bosch MED9.1 · WinOLS mappack + original file
0261S02342 1037384214 8P0907115H 0020 Bosch MED9.1 WinOLS mappack
Audi S3
HW0261S02342
SW1037384214
Maps205
- One ZIP by e-mail: the original .bin + the .csv mappack for WinOLS
- Maps with correctly labelled X and Y axes in the right format and the correct factor for the data values
- Tuning maps only — no maps for switching off emission systems or errors
- Axes checked against this exact original: 260 of 264 read correctly
- No account — your e-mail and a card
- Check the HW / SW above against your read — all sales are final
€60original + mappack
VISAMastercardApple PayGoogle Pay
Engine Torque 37 mapsTurbo System 32 mapsSpark Advance 29 mapsRail 26 mapsLimiters 25 mapsInjection System 24 mapsAir Control 20 mapsVariable Valve Timing (VVT) 10 mapsDeactivations 2 maps
Engine Torque 37 maps
- Calculated engine torque 9 maps
- Desired torque at wheel
- Engine torque correction
- Limiter of Maximum torque - ECO
- Optimal engine torque 2 maps
- Torque limiter for clutch protection
- Torque monitoring 16 maps
- Torque request during take off condition - Fifth Gear
- Torque request during take off condition - First Gear
- Torque request during take off condition - Forth Gear
- Torque request during take off condition - Second Gear
- Torque request during take off condition - Sixth Gear
- Torque request during take off condition - Third Gear
Turbo System 32 maps
- Correction of slow incremental factor of turbo pressure
- Correction of turbo pressure
- Correction of turbo pressure f(IAT) 10 maps
- Fast reduction factor of turbo pressure
- Limiter of Turbo pressure 5 maps
- Limiter of Turbo pressure f(IAT)
- Limiter of impulsive turbo pressure 3 maps
- Limiter of steady turbo pressure 3 maps
- Overboost duration
- Slow incremental factor of turbo pressure
- Turbo pressure 2 maps
- Wastegate Duty Cycle 3 maps
Spark Advance 29 maps
- Limiter of knocking sensor 4 maps
- Minimum Spark Advance 12 maps
- Optimal Spark Advance 4 maps
- Spark Advance base map 6 maps
- Spark advance during cranking 3 maps
Rail 26 maps
- Calibration of the fuel pressure sensor
- Fuel pressure constant setpoint
- Fuel pressure correction during cranking 2 maps
- Fuel pump duty cycle
- Fuel volume for compression in the high pressure fuel pump
- High pressure fuel pump flow
- Maximum compression for the high pressure fuel pump
- Maximum duty cycle for fuel pump
- Maximum pressure for fuel pump 2 maps
- Maximum rail pressure for open PRV
- Rail pressure 6 maps
- Rail pressure limiter
- Rail pressure limiter f(RPM,Fuel_Q)
- Rail pressure limiter f(RPM,Fuel_T)
- Square radius of the piston in the High pressure fuel pump
- Threshold for maximum rail pressure error
- Threshold for minimum rail pressure error
- Time constant error debouncing max value
- Time constant error debouncing min value
Limiters 25 maps
- Maximum speed of vehicle 5 maps
- RPM Limiter 17 maps
- RPM limiter (higher threshold) 3 maps
Injection System 24 maps
- Conversion of relative fuel mass into effective injection time
- Injection correction 6 maps
- Injection enrichment
- Injector offset dependent on voltage
- Lambda for component protection 6 maps
- Overrun injection cut off Delay Time
- Overrun injection cut off engine speed lower threshold 3 maps
- Overrun injection cut off engine speed lower threshold AC OFF
- Overrun injection cut off engine speed lower threshold AC ON
- Requested Lambda 3 maps
Air Control 20 maps
- Airflow mass through throttle valve 2 maps
- Engine load limiter 5 maps
- Exhaust gas temperature 3 maps
- MAF sensor slope
- MAP sensor maximum voltage
- MAP sensor minimum voltage
- MAP sensor offset
- MAP sensor slope
- Maximum MAP sensor
- Requested engine load
- Threshold of end limitation on throttle valve angle
- Throttle valve - operating angle
- Throttle valve f(Accelerator pedal)
Variable Valve Timing (VVT) 10 maps
- Intake 10 maps
Deactivations 2 maps
- Catalytic converter Diagnosis (1=ON, 0=OFF)
- Lambda Sensor (1=ON, 0=OFF)
Names only here — sizes, axes and positions come in the .csv.
What you get
0261S02342_1037384214_original.binThe original (stock) read of Bosch MED9.1 0261S02342 1037384214 8P0907115H 0020 — ready to open.
0261S02342_1037384214_mappack.csvWinOLS map export: 205 tuning maps with names, categories, sizes, labelled X / Y axes, factors and positions — import it into your WinOLS project.
What is in our map packs. Maps with correctly labelled X and Y axes in the right format and the correct factor for the data values, ready to read. Tuning maps only — no maps for switching off emission systems or errors.
Questions
What is a WinOLS mappack?
The definitions of the maps in one ECU software version — name, category, size, axes and position — exported from WinOLS as a CSV. It is not a DAMOS or A2L file and holds no tuned values.
Will it fit my ECU?
It is made for this software version: compare the HW / SW numbers above with your read.
Why €60?
Our map-pack prices, the original file included: cars €60 when the ECU type came out before 2012, €70 from 2012 on; motorcycles and boats €80; trucks and agricultural machinery €90.
Refunds?
All sales are final — check the numbers and the map list before you buy.
Need a map pack for another file?
Write to us on WhatsApp — we will tell you whether we can make one for your file and what it costs.
All Bosch MED9.1 mappacks · This original file · Search all mappacks
€60